Hello.
Small guide about reviving dead SPD phones.
In
CM2SPD module exists
"Repair Tab" 
- If we have dead SPD phone by some other tool, or just dead/blinking and it NOT want format, or network or some else problems, for example , we need :
1. Get
ANY SPD65xx ( depend on your phone - if your dead SPD6531 - you need ANY SPD6531 phone ) or ANY dump from this CPU. Just 1 minutes to search on forum.
You DON'T NEED SEEK DAYS/WEEKS/MONTH PHONE ORIGINAL DUMP , JUST USE ANY. a) Have a same CPU Phone
Make "Read NV" on this alive phone.
Quote:
P.S. :
GCNV :
If you want use it as main file always to repair - save it to folder "gcnv" ( go to previous folder during select save location ) folder in CM2SPD backup folder.
It will be used automatically on next repair process on this CPU.
Or just save it anywhere and name as you like.
If you want use file as auto - just tick "FFS" and "NV" and not tick "Use File", press "Repair"
This just save time, when you need repair much phones in a row.
POSSIBLE PROBLEMS :
Also, in some cases , CM2 can build not correct NV due some much differs between phones. It can be after : Not Run, Reboot, No Network. For clear results - always better use phones/dumps from your local area, which have correct settings inside for network and rest things.
|
If you want select backup, which you made earlier - select also "Use File" , press "Repair". Follow software instructions. When boot done and all ready - CM2 ask select NV. Select it and it will continue repair.
b) Have a same CPU Dump
Just tick "Use File" , select "FFS" and "NV" , press "Repair". When boot done and all ready - CM2 will ask about select NV , select this dump. CM2 will analyze and find need data in this file and will continue repair.
Also. if you want make process more fast - enter in security field your repaired phones IMEI from back sticker to fields , before press "Repair". CM2 will ask about Repair security, when it will repair NV and FFS.
Proof Of :
Here, for example, one from much cases :
http://forum.gsmhosting.com/vbb/10713025-post120.html - If phone doesn't want format , and show in log message, like this :
Code:
Sending boot ...
Boot Sent , starting...
Boot Ver : Spreadtrum Boot Block version 1.2
Boot Ok
CPU ID : 6531 , FDLStat : 0100
[0] Flash DIE : 00C8 0060 0018 0000
[0] Flash VEN : GigaDevice , GD25LQ128
[0] Flash CAP : 01000000
Verify data... Can take some time
Init Ok, formatting DIN area ...
Format Block Done!
Error while prepare!
Format error, something went wrong
just tick "FFS" in repair and press "Repair". After few seconds mobile will be fixed and this error will gone. No need format after that procedure again.
