samsung clone s7582 mt 6572 sucess fully flash Load File
File_Info : hexing72_wet_jb3
FileVersion : MT6572
Load File Ok
Operation : Flash [ v1.12 ]
======= Flash
Files set for flashing :
[ MCU ] : read.bin
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey
Wait for phone...
Phone found! [ 7 ]
Sync...
Inital regs read done
Boot Info :
BB_CPU_ID : 6572
BB_CPU_HW : CA01
BB_CPU_SW : 8A00
BB_CPU_SB : 0000
BB_CPU_NM : [MediaTek] MT6572_S00
Processing BROM stage
BLVersion : 0x01
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 1501004E35585A4D42011E1AC282519B
DA Stat : v4.2 on BBID : 0x88
DA Sent. Configure setting now ...
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0015 , OEM : 0100
[eMMC] : FLASH_INF : BMZX5
[eMMC] : FLASH_CID : 1501004E35585A4D42011E1AC282519B
[eMMC] : FLASH_LEN : 0x00000000E9000000
INT RAM : 0x00020000
EXT RAM : 0x20000000
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!
Brand : alps
ProdName : hexing72_wet_jb3
ProdModel : GT-I9082
Device : hexing72_wet_jb3
AndroidVer: 4.0.4
MTKxCPU : MT6572
MTKxPRJ : ALPS.JB3.MP.V1.6
ISPFF ID : 6572
TARGET ID : 6572
Flash pre-erase enabled
Erase Flash now ...
Flash pre-erase done
Write Flash now ...
[ MCU ] : read.bin
Init Ok , Sending blocks ...
Write done , 3728 blocks sent
Done!
Elapsed: 00:13:25
Reconnect Power/Cable!
Thanx Chainess miracle cm2
but in this file when i touch dial button it goes to massage menue any solution for this |