@AonMobilles,
This Adapter 4 in 1 V3 is the same of V2, (not V1 attention), so No need any resistorr more but this coming just already.
Must need of READ carefully how to set Adapter for EMMC direct then use pinout posted in first post of this thread.
If this is you Log:
Quote:
ERROR: EMMC WAS NOT Detected! (CMD1)
Check your Test Point Soldering!
CMD1 Reply: 0x5E5E5E5E |
It's Not bad, is good reply EMMC is been detected only need of ceck and adjust VCCIO in SW or re ceck all wires soldered.
If is how Screenshoot, you connection with Adapter is very Bad.
Read carefully how setup the V3 here:
http://forum.gsmhosting.com/vbb/f609...hting-1834819/
in first post.
Is clear that you connection is setted BAD for this you EMMC isn't detected.
@MR.MAMUN, same for you, first post wwhat type of adapter you have then if have V1 need of solder resistor, all connection in Adapter are write clear in Sticky Thread, just read.
Br
allumts