GSM-Forum - View Single Post

Mishel · 12-09-2016, 08:56

Thank you for your endless patience and correct English Mr. A^A

Xiomi Note 3 Pro (kenzo)

Remove Account (Acc)
Step 1

Quite simple step actually:
I assume all drivers are installed properly (CHECK!)

1. Don't open MRT yet, keep it close
2. Plug the cable into the phone, and put it on EDL mode
3. Make sure it's properly detected in device manager
4. Open MRT, pick Redmi Note 3 from drop down list
5. Finally click Remove Account

Done, turn it on, enable adb, and proceed Remove APK steps.

Step 2

No need root at all. Windows 10 suported.
Better using version 7.3.2 for higher success rate, especially for Note 3 Pro

Enable USB debuging, get user permissions from phone .

1. Make sure adb driver that installed in your system is the latest one.
2. Don't open MRT yet
3. Enable ADB in the phone (you know how to do this one)
4. Plug the cable into the phone, make sure phone properly detected in the device manager
5. Open ADB CMD prompt, and type adb devices, look at your phone screen, there should be an ADB notification ask for manual permission
6. Dont forget to TICK (always give) and click OK to allow it
7. Open MRT, finally click Remove APK

Screenshots and original thread http://forum.gsmhosting.com/vbb/f492...filed-2164863/

To be continued....

12-09-2016, 08:56	#4 (permalink)
Mishel Freak Poster Join Date: Jul 2004 Location: Ukraine Posts: 451 Member: 74053 Status: Offline Thanks Meter: 75	Thank you for your endless patience and correct English Mr. A^A Xiomi Note 3 Pro (kenzo) Remove Account (Acc) Step 1 Quite simple step actually: I assume all drivers are installed properly (CHECK!) 1. Don't open MRT yet, keep it close 2. Plug the cable into the phone, and put it on EDL mode 3. Make sure it's properly detected in device manager 4. Open MRT, pick Redmi Note 3 from drop down list 5. Finally click Remove Account Done, turn it on, enable adb, and proceed Remove APK steps. Step 2 No need root at all. Windows 10 suported. Better using version 7.3.2 for higher success rate, especially for Note 3 Pro Enable USB debuging, get user permissions from phone . 1. Make sure adb driver that installed in your system is the latest one. 2. Don't open MRT yet 3. Enable ADB in the phone (you know how to do this one) 4. Plug the cable into the phone, make sure phone properly detected in the device manager 5. Open ADB CMD prompt, and type adb devices, look at your phone screen, there should be an ADB notification ask for manual permission 6. Dont forget to TICK (always give) and click OK to allow it 7. Open MRT, finally click Remove APK Screenshots and original thread http://forum.gsmhosting.com/vbb/f492...filed-2164863/ To be continued.... Last edited by Mishel; 12-09-2016 at 09:03.