vivo X9s enable diag now on logo Device : Vivo X9
Operation : Format FS
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM15)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1009900 [8976] 00000000
OPK_DATA : 30315EBED1DD09CEAAE927CAE0EE967076BC178CA33718DB4F FF8F02A0E7FAD2
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8976_003.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8976, eMMC, 64 GB
LU Count : 1 [0x0747C000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : vivo vivo [msm8952]
Software : NMF26F release-keys, eng.compil.20180201.204039 [2018年 02月 01日 星期四 20:40:39 CST]
Android Ver. : 7.1.1
Patch Level : 2017-12-01
Preparing Data...Done
Formatting Userdata...Done
Finalizing...Done
Operation Finished.
Module Ver. 2.0
after doing this still on vivo logo from where to get firmware of this mode ? |