Redmi Y1(UGG)|Android 7.1.2| Disable Lock Successfully By UMT Qcfire.
Code:
Operation : Disable Locks
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM74)
Driver Info : Huawei Incorporated, qu_usb_serial.sys, 2.1.1.0
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1B00600 [8937] 00000000
OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD379930D5891E3D8240B
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8937_003.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8937, eMMC, 64 GB
LU Count : 1 [0x0747C000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi Note 5A [msm8937]
Software : N2G47H, 8.4.28 [Sat Jun 9 07:26:41 WIB 2018]
Android Ver. : 7.1.2
Patch Level : 2018-04-01
USERDATA : Encrypted
Disabling Android Locks...Done
Operation Finished.
Module Ver. 2.5
Regards
Rizwan