hi guy ,
the following may help if followed care fully to a result;
1.note that if you remove the lcd of t610,for you to replace it back the inlet (that is were you need to insert the flex) you have to make sure that it fit-in properly.
2.also note again that as you try insertying the flex it does not bend,if not there will be a broke-in which may laed to faulty flex.
3.if that is done am sure it will glew fine and your problem solve!
NOTE; B4 THIS ,MAKE SURE THERE IS DEPOSIT ON THE SUREFACE OF THE FLEX. GOOD LUCK! |