[legija]

RIFF Box Firmware v1.51

- fixed RIFF1 firmware bug which caused random box restarts during ISP flashing
- fixed RIFF1 firmware bug which caused freezing during consequtive eMMC write operations in single session
- fixed RIFF1 & RIFF2 firmware bug which caused erasing the first block of eMMC chip's user area after reading eMMC firmware or reading Samsung Smart Info


RIFF Box JTAG Manager v1.81

- added USB mode: it is possible to connect supported devices via USB cable; (Qualcomm Sahara Firehose and Streaming Download protocols)
- added UFS memories support via USB interface.
- added feature to remember each partition address and length settings on USB read/write page;
- added feature to remember each partition address and length settings on eMMC read/write page;
now when partition is changed, the relevant Address and Length fields are changed to correspond values which were set for selected partition;
- fixed an issue with settings when there are no downloaded resurrectors or if there are not all kinds of resurrectors are present;
Now informative dialogs are displayed for users to be able to clue out what's to be done.
- fixed an issue when user tries to select Resurrectors filter (for example to filter only ISP Resurrectors) and there are no Resurrectors of the selected Filter kind;
Now informative dialogs are displayed for users to be able to clue out what's wrong. And deadloop with settings is avoided now.
- added information on the Plugins page - in case there are no plugins are downloaded yet, the not experienced user can see information about plugins and how to get them;
- revised the "Resurrector Settings" logic: renamed to "Automatic Parameters" and "Manual Parameters by User".
When selected "Automatic Parameters", the required connection settings are used from the Resurrector DLL: for all modes - JTAG, eMMC, USB.
Please note, any settings (values) present in the ISP Resurrector DLLs are copied when DLL is selected and are not forced not to be changed later by user.
Thus for ISP mode, all settings (interface, SD_CLK, voltage and bus width) can be modified anytime, and are not grayed out in the "Automatic Parameters" mode.
When selected "Manual Parameters by User", the required connection settings are used from correspondent fields.
Additional checks added to eliminate irregularities during connection to the device when incorrect mode DLL is selected in the list.
Message dialogs are displayed to inform user what has to be done in order to fix the problems
- completely reworked scenarios for cases when "Automatic Parameters" or "Manual Parameters by User" option is selected
It now complies to following rules: when "Manual Parameters by User" are selected, the settings block is changed depending to currently active Page.
For example, if eMMC Read/Write page is active, ISP settings block is displayed, if DCC Read/Write page is active, JTAG Custom Settings block is displayed, etc.
In case "Automatic Parateres" is selected, no matter what active page is selected, the settings block which corresponds to the mode of selected resurrector is displayed.
This helps to eliminate illogical scenarios - for eample, when selected resurrector is ISP Resurrector and user tries to Read/Write memory on DCC Read/Write Page.
In this case Error Message dialog is displayed for user.
- implemented more informative and self-explainable run-time rebuild of the JTAG Manager's settings blocks interface when Automatic Parameters" or "Manual Parameters by User" are selected.