GSM-Forum - View Single Post

DUSKnenixs · 10-02-2018, 14:01

asus me173x

HiPower mode is ON
Setting frequence to 21 Mhz
CMD Pullup Level: 1815 mV
CMD Active Level: 1825 mV
EMMC Device Information :
EMMC CID: 02000053444D30333290FFFFFFFF29BC
EMMC CSD: 8C0F002A015981E9B6D9FC1F8A4040AA
EMMC Manufacture : , EMMC NAME: SDM032 , HEX: 53444D303332 , S/N: FFFFFFFF , rev. 0x90
EMMC Manufacture ID: 0x02 , OEM ID: 0x00 , Device Type: Device (removable) , Date: 2/2006
EMMC ROM 1 (Main User Data) Capacity: 30 MB (000001E9C000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 0 KB (000000000000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 0 KB (000000000000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.0 (MMC 4.0)
Boot configuration [PARTITION_CONFIG]: 0x00 , Boot from: no boot
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x00
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: SDM032_FFFFFFFF_20181002_135956.extcsd
EMMC Init completed.

eMMC are unusable.

semms dead ic? need a new one?

10-02-2018, 14:01	#1 (permalink)
DUSKnenixs No Life Poster Join Date: Jul 2001 Location: Planet earth Posts: 2,641 Member: 5169 Status: Offline Thanks Meter: 684	dead emmc? need replacement? asus me173x HiPower mode is ON Setting frequence to 21 Mhz CMD Pullup Level: 1815 mV CMD Active Level: 1825 mV EMMC Device Information : EMMC CID: 02000053444D30333290FFFFFFFF29BC EMMC CSD: 8C0F002A015981E9B6D9FC1F8A4040AA EMMC Manufacture : , EMMC NAME: SDM032 , HEX: 53444D303332 , S/N: FFFFFFFF , rev. 0x90 EMMC Manufacture ID: 0x02 , OEM ID: 0x00 , Device Type: Device (removable) , Date: 2/2006 EMMC ROM 1 (Main User Data) Capacity: 30 MB (000001E9C000) EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 0 KB (000000000000) EMMC RPMB (Replay Protected Memory Block) Capacity: 0 KB (000000000000) EMMC Permanent Write Protection: No EMMC Temporary Write Protection: No Extended CSD Information : Extended CSD rev: 1.0 (MMC 4.0) Boot configuration [PARTITION_CONFIG]: 0x00 , Boot from: no boot Boot Bus Config: 0x00 , width 1bit H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled Supported partition features [PARTITIONING_SUPPORT]: 0x00 Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00 Backup saved: SDM032_FFFFFFFF_20181002_135956.extcsd EMMC Init completed. eMMC are unusable. semms dead ic? need a new one?