| Nokia 3310 TA-1030 Language flash done
Nokia 3310 TA-1030 Language flash done
--------------------------
Card found : 07XXXXXX , v0122
Infinity-Box BEST Nokia [HMD] Module [NK2] v1.09
Open VPLfile : TA1030_059X9V9_11.02.11.vpl
Description : TA-1030 NDT EURO ED GREY LATIN HR
DeviceType : TA-1030
ProductCode : 059X9V9
SoftwareVer : 11.02.11
PPM LangPack :
[1] : Slovenian (Slovenia)
[2] : Croatian (Croatia)
[3] : Hungarian (Hungary)
[4] : Bosnian (Bosnia and Herzegovina)
[5] : FYRO Macedonian (Former Yugoslav Republic of Macedonia)
[6] : English (United Kingdom)
Load Ok!
Operation : Write FirmWare [ v1.09 ]
Setting : UserData erase : False
Setting : LangPack Only : True
1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...
PTFN : Care Suite USB Serial Port (COM925)
MODE : NOKIA USB SERIAL
PORT : 925
Error : Failed to open port!
Error : Fail to init protocol!
Remove battery, cable. Check cable and connection. Repeat operation!
Reconnect Power/Cable!
Operation : Write FirmWare [ v1.09 ]
Setting : UserData erase : False
Setting : LangPack Only : True
1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...
PTFN : Care Suite USB Serial Port (COM925)
MODE : NOKIA USB SERIAL
PORT : 925
BROM : Init BROM
BROM init passed!
CHIP : MT6260 , SBID : 0xCB00 , HWVR : 0x8000 , SWVR : 0x0000
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : 751CDCCB483FC9407EDBBA22A14B8813
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : RETRO.11.02.11.p1
BOOT : SWR : 11.02.11
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6260
AGENT : RETRO.11.02.11.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Agent : v03.02 on BBID : 0x8B
NOR: 00C2 : 0025 : 0038 : 0000
NOR: [MXIC] MX25U12835FZNI_10G
NOR:
TSIZE : 0x01000000 [ 16.00 MB ]
PSIZE : 0x01000000 [ 16.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST
STATUS : OK
BSTYLE : SF_FLASH_BOOT
Boot done!
VPL SoftwareVersion : 11.02.11 [TA-1030]
DEV SoftwareVersion : 11.02.11
SWInfo compare result : SAME
Load FlashSet :
LANG : TA-1030_LANG_PACK_ROM_ED_eMP_11.02.11_001
CUST : TA-1030_CUSTPACK_ROM_ED_EURO_HR_eMP_11.02.11_001
JUMP : TA-1030_JUMP_TABLE_ED_EURO_HR_eMP_11.02.11_001
Prepare FlashSet :
DCR : TA-1030_LANG_PACK_ROM_ED_eMP_11.02.11_001
DCR : TA-1030_CUSTPACK_ROM_ED_EURO_HR_eMP_11.02.11_001
DCR : TA-1030_JUMP_TABLE_ED_EURO_HR_eMP_11.02.11_001
Prepare Target
SDS : OK : 0x00FF4000 : 0x0000C000
Erase Target Flash
Erase done!
Write Target Flash
Write : TA-1030_LANG_PACK_ROM_ED_eMP_11.02.11_001
Write : TA-1030_CUSTPACK_ROM_ED_EURO_HR_eMP_11.02.11_001
Write : TA-1030_JUMP_TABLE_ED_EURO_HR_eMP_11.02.11_001
Write done, waiting target response ...
Write flash done!
Verify Target FlashContent
Verify : TA-1030_LANG_PACK_ROM_ED_eMP_11.02.11_001
Verify : TA-1030_CUSTPACK_ROM_ED_EURO_HR_eMP_11.02.11_001
Verify : TA-1030_JUMP_TABLE_ED_EURO_HR_eMP_11.02.11_001
Done!
Elapsed: 00:01:26
Reconnect Power/Cable! |