Quote:
Originally Posted by simpleprince49 i use easy jtag plus box..the black one
this is my 1st time to use spi flasher..im confused in 3.3v of this pinouts in bios chip
WP VCC HOLD..i tried to connect all of them at same pin in rj45 but its not working
also tried to connect WP to pin 17 with resistor
i also tried to put 1.8v 2.8v 3.3v in software but when i put tester in vcc pin voltage is not changing..always at 4.2v |
I was wrote pinout to you.
PIN 17 - 1.8 - 3.3V (power from box) You doun't need use RJ45!!!!!