GSM-Forum - View Single Post - Sigma v.2.32.01. Huawei FRP Remove via testpoint improvements

GSM_Support · 05-22-2019, 12:18

MANUAL: FRP Remove using Testpoint for HiSilicon based devices

Testpoints gallery: boot-loader.com -> Downloads -> Sigma Free Section -> Testpoints
Drivers for device HUAWEI USB COM 1.0

Procedure:

Select "HISILICON" platform from the tab menu in the upper left side of the software
Go to "Service" bookmark
Select from drop-down list the required platform that fits to your device HiSilicon [ Kirin XXX ][v].
If you do not select the platform, the software will ask you to select *.xml file from the factory software that fits this phone (in the manufacturer's original format).
Connect the phone to PC using USB cable in the FACTORY mode (Testpoint has to be used)
Device should be detected as HUAWEI USB COM 1.0 device (VID12D1 PID3609) in the System.
Select "HUAWEI USB COM 1.0 device" in the ports selection tab.
Press "Remove FRP" button
The message "Removing FRP… Done" indicates that procedure has been completed successfully
Disconnect the handset from PC

Video tutorials

Best Regards
GSMServer team

05-22-2019, 12:18	#2 (permalink)
GSM_Support Product Supporter Join Date: Feb 2005 Location: GSMserver Team Posts: 36,980 Member: 121052 Status: Offline Sonork: 100.107126 Thanks Meter: 80,766	MANUAL: FRP Remove using Testpoint for HiSilicon based devices Testpoints gallery: boot-loader.com -> Downloads -> Sigma Free Section -> Testpoints Drivers for device HUAWEI USB COM 1.0 Procedure: Select "HISILICON" platform from the tab menu in the upper left side of the software Go to "Service" bookmark Select from drop-down list the required platform that fits to your device HiSilicon [ Kirin XXX ][v]. If you do not select the platform, the software will ask you to select .xml file from the factory software that fits this phone (in the manufacturer's original format). Connect the phone to PC using USB cable in the FACTORY mode (Testpoint has to be used) Device should be detected as HUAWEI USB COM 1.0 device (VID12D1 PID3609) in the System. Select "HUAWEI USB COM 1.0 device" in the ports selection tab. Press "Remove FRP" button The message "Removing FRP… Done" indicates that procedure has been completed successfully Disconnect the handset from PC Video tutorials* Best Regards GSMServer team Last edited by Gsmserver; 05-23-2019 at 11:28.