Code:
Device : JIO F90M
Operation : Read Information
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1400900 [8909] 00000000
OPK_DATA : 40EC2E6F16D8D2FF04813324C69AAE78DABE3BDC649086A37100C9F00E237215
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8909_037]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 4 GB
LU Count : 1 [0x00748000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : LYF F90M [msm8909] [F90M]
Software : LYF-F90M-000-03-19-240319, LYF-F90M-000-03-19-240319 [Sun Mar 24 13:25:48 HKT 2019]
Android Ver. : 6.0.1
Patch Level : xxxx-xx-xx
USERDATA : Normal
You can use RESET LOCKS to remove Pin/Pattern/Password WITHOUT Data Loss.
Operation Finished.
QcFire Ver. 4.6
Operation : Flash
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1400900 [8909] 00000000
OPK_DATA : 40EC2E6F16D8D2FF04813324C69AAE78DABE3BDC649086A37100C9F00E237215
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8909_037]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 4 GB
LU Count : 1 [0x00748000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Writing [NON-HLOS.bin] -> [modem] ...Done
Writing [sbl1.mbn] -> [sbl1] ...Done
Writing [sbl1.mbn] -> [sbl1bak] ...Done
Writing [emmc_appsboot.mbn] -> [aboot] ...Done
Writing [emmc_appsboot.mbn] -> [abootbak] ...Done
Writing [rpm.mbn] -> [rpm] ...Done
Writing [rpm.mbn] -> [rpmbak] ...Done
Writing [tz.mbn] -> [tz] ...Done
Writing [tz.mbn] -> [tzbak] ...Done
Writing [splash.img] -> [splash] ...Done
Writing [fs_image.tar.gz.mbn.img] -> [fsg] ...Done
Writing [sec.dat] -> [sec] ...Done
Writing [system_1.img] -> [system] ...Done
Writing [system_2.img] -> [system] ...Done
Writing [system_3.img] -> [system] ...Done
Writing [system_4.img] -> [system] ...Done
Writing [system_5.img] -> [system] ...Done
Writing [system_6.img] -> [system] ...Done
Writing [system_7.img] -> [system] ...Done
Writing [system_8.img] -> [system] ...Done
Writing [system_9.img] -> [system] ...Done
Writing [system_10.img] -> [system] ...Done
Writing [system_11.img] -> [system] ...Done
Writing [persist_1.img] -> [persist] ...Done
Writing [usbmsc_1.img] -> [usbmsc] ...Done
Writing [usbmsc_2.img] -> [usbmsc] ...Done
Writing [usbmsc_3.img] -> [usbmsc] ...Done
Writing [usbmsc_4.img] -> [usbmsc] ...Done
Writing [usbmsc_5.img] -> [usbmsc] ...Done
Writing [usbmsc_6.img] -> [usbmsc] ...Done
Writing [usbmsc_7.img] -> [usbmsc] ...Done
Writing [usbmsc_8.img] -> [usbmsc] ...Done
Writing [usbmsc_9.img] -> [usbmsc] ...Done
Writing [usbmsc_10.img] -> [usbmsc] ...Done
Writing [usbmsc_11.img] -> [usbmsc] ...Done
Writing [usbmsc_12.img] -> [usbmsc] ...Done
Writing [usbmsc_13.img] -> [usbmsc] ...Done
Writing [cache_1.img] -> [cache] ...Done
Writing [cache_2.img] -> [cache] ...Done
Writing [cache_3.img] -> [cache] ...Done
Writing [boot.img] -> [boot] ...Done
Writing [recovery.img] -> [recovery] ...Done
Writing [userdata_1.img] -> [userdata] ...Done
Writing [userdata_2.img] -> [userdata] ...Done
Writing [userdata_3.img] -> [userdata] ...Done
Writing [userdata_4.img] -> [userdata] ...Done
Writing [userdata_5.img] -> [userdata] ...Done
Writing [userdata_6.img] -> [userdata] ...Done
Writing [userdata_7.img] -> [userdata] ...Done
Writing [userdata_8.img] -> [userdata] ...Done
Writing [userdata_9.img] -> [userdata] ...Done
Writing [userdata_10.img] -> [userdata] ...Done
Writing [userdata_11.img] -> [userdata] ...Done
Writing [userdata_12.img] -> [userdata] ...Done
Writing [gpt_main0.bin] -> [PrimaryGPT] ...Done
Writing [gpt_backup0.bin] -> [BackupGPT] ...Done
Applying Patches................Done
Resetting device...Done
Operation Finished.
QcFire Ver. 4.6