GSM-Forum - View Single Post - Can't init EMMC, Reason: CARD Operation Condition Timeout Error

recan21 · 10-14-2019, 17:41

help!!
Z3X EasyJtag Software ver. 3.6.1.15
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 0707071F24C202D1, ,FW Ver.: 01.63
CMD Pullup Level:2010 mV
CMD Active Level:2351 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
Can't init device, Reason: CARD Ready Timeout Error
Done.

here another error with same device :

i think device is dead after connection with jtag !!
it's OPPO A3S!

10-14-2019, 17:41	#61 (permalink)
recan21 No Life Poster Join Date: Jan 2005 Location: ALGERIA Age: 53 Posts: 1,040 Member: 112185 Status: Offline Sonork: 100.1612613 Thanks Meter: 163	help!! Z3X EasyJtag Software ver. 3.6.1.15 Loading eMMC GEN1 Firmware... IO: 2800 mV Box S/N: 0707071F24C202D1, ,FW Ver.: 01.63 CMD Pullup Level:2010 mV CMD Active Level:2351 mV Box IO Level:2800 mV CLK Rate:21000 kHz Bus Width:1bit,SDR HiPower mode is ON! Can't init device, Reason: CARD Ready Timeout Error Done. here another error with same device : i think device is dead after connection with jtag !! it's OPPO A3S! Last edited by layder; 10-14-2019 at 20:56. Reason: merge posts