infi is here
Code:
Z3X EasyJtag Software ver. 3.6.2.3
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 0100C01CD5DD0243, ,FW Ver.: 01.63
CMD Pullup Level:2660 mV
CMD Active Level:2763 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------
eMMC CID : 90014A483847347592011D4980F715BE
eMMC CSD : D02701320F5903FFFFFFFFE78A40002A
eMMC Manufacturer ID: 0090 , OEM ID: 014A
eMMC Date: 01/2018 Rev.0x1
eMMC NAME: H8G4u , S/N: 491356407
eMMC NAME (HEX): 483847347520
EMMC ROM1 (Main User Data) Capacity: 7456 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
EMMC RPMB is programmed and written 0 times
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.7 (MMC 5.0)
Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x48.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00002000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: H8G4u_ 491356407_20200421_1421.extcsd
Partition info not found
Done.
Selected eMMC Interface
Failed to load partition