Platform: LG MTK
Selected port: COM3
Selected baudrate: 921600
Selected model: K500UM
Selected USB connection type
Please, disconnect cable, power phone OFF, connect P999 cable (with 910k resistor)
or
Power OFF phone, press and hold "Vol+" for 10 seconds and connect USB cable.
Phone found at port COM22
Mode: Emergency
Initializing flash...OK
Model ID: LM-K500UM
Platform: mt6765
Android version: 9
SW version: LMK500UM3AT-00-V10f-310-120-JUL-24-2020-ARB00+1
LAF Version: 1.1
Product ID: VS03S200512002450
IMEI: 352488-11-187115-9
Target operator: LAO
Hardware: rev_10
Battery level: 86%
Reading partitions...OK
LAF Error: 80000119.
Checking security...OK
--------------------------------------------------------------------------------
IMEI: 352488-11-187115-9
Bluetooth address: Unknown
Wi-Fi MAC address: Unknown
--------------------------------------------------------------------------------
Write security backup function doesn't work for this device with latest firmware versions. If you'll encounter any problem during Unlock operation - you won't be able to restore the phone to it's initial state, so proceed at your own risk.
Continue?
Warning: After Unlock operation your device may have some issue with sending and receiving SMS or MMS messages.
Continue?
Connecting to server...OK
Octopus smart card is present.
Checking smart card...OK
Username: Dubr509
Authorizing...OK
Checking balance...OK
Checking operation...OK
Sending device information...OK
Get credits, needed for current operation...OK
Your balance: 100 credits.
To perform "Unlock" operation you need to have 100 credits.
Unlocking...OK
Writing security area...
Initializing flash...OK
Writing security area...OK
Initializing flash...OK
Reading partitions...OK
Prepairing for change protect status...
Initializing flash...OK
Removing write protection...OK
Initializing flash...OK
Reading partitions...OK
Prepairing for change protect status...
Initializing flash...OK
Removing write protection...OK
Initializing flash...OK
Reading partitions...OK
Prepairing for change protect status...
Initializing flash...OK
Removing write protection...OK
Initializing flash...OK
Reading partitions...OK
Prepairing for change protect status...
Initializing flash...OK
Removing write protection...OK
Initializing flash...OK
Reading partitions...OKFailed!
Warning: If your device were stuck at logo, after operation was completed, then please, don't reflash your device, first contact with Support via Skype or create thread at forum!
Performed by 3.0.3.03 Software version.
phone failed unlocked need credits back ...
