Hello...
I'm unable to unlock Moto XT-2097-7 or even identify the device in all modes using CM2MT2, here is log using flash mode:
Code:
Operation : SP Unlock [ v2.32 ]
Mode : FLASH
1. Make sure device is powered off. Power off, if need. Wait 20 seconds after
2. Insert USB cable in phone
Waiting for device connection ...
PTFN : MediaTek PreLoader USB VCOM (Android) (COM106)
MODE : PRELOADER PORT
PORT : 106
Waiting BOOT ack ...
PRELOADER : ACK confirmed!
BROM : Init BROM
BROM init passed!
CHIP : MT6765 , SBID : 0x8A00 , HWVR : 0xCA00 , SWVR : 0x0000
CODE : Cervino
TYPE : MODERN [RAPHAEL]
BROM : SecLevel : 0x00000005
BROM : SecMode : SBC+SDA
BROM : BROM|BL : 0xFF|0x03
BROM : PRELOADER PORT
AGENT : 0_base : BASE_v2112 | Manual : Disabled
AGENT : Look for suitable BootChain in DA ...
AGENT : DA_PL.bin
AGENT : Found MT6765
AGENT : MTK_DOWNLOAD_AGENT
BROM : Sending 1st DA ...
BROM : Reset Interface!
PTFN : MediaTek PreLoader USB VCOM (Android) (COM106)
MODE : PRELOADER PORT
PORT : 106
Waiting BOOT ack ...
PRELOADER : ACK confirmed!
BROM : Init BROM
BROM init passed!
CHIP : MT6765 , SBID : 0x8A00 , HWVR : 0xCA00 , SWVR : 0x0000
CODE : Cervino
TYPE : MODERN [RAPHAEL]
BROM : SecLevel : 0x00000005
BROM : SecMode : SBC+SDA
BROM : BROM|BL : 0xFF|0x03
BROM : PRELOADER PORT
AGENT : 0_base : BASE_v2112 | Manual : Disabled
AGENT : Look for suitable BootChain in DA ...
AGENT : DA_PL.bin
AGENT : Found MT6765
AGENT : MTK_DOWNLOAD_AGENT
BROM : Sending 1st DA ...
BROM : 0x00007024 : DA SEND ERROR!
ERROR : SECURE BOOT : SELECTED DA NOT SUPPORTED IN CURRENT DEVICE STATE!
INFO : PRELOADER Level : CORRECT DA required : PL/PL_CRYPTO/SWSEC
Error : Fail to init protocol!
>>> Remove battery, cable. Check cable/connection/driver! Check SW hint! Repeat operation!
Reconnect Power/Cable! Unlock log using META mode:
Code:
Operation : SP Unlock [ v2.32 ]
Mode : META
1. Make sure device is powered off. Power off, if need. Wait 20 seconds after
2. Insert USB cable in phone
Waiting for device connection ...
PTFN : MediaTek PreLoader USB VCOM (Android) (COM106)
MODE : PRELOADER PORT
PORT : 106
Waiting BOOT ack ...
PRELOADER : ACK confirmed!
INIT : META confirmed!
Boot done!
AP_CHIP : MT6765
AP_SWTM : Tue Sep 14 15:43:58 CST 2021
AP_SWVR : alps-mp-q0.mp1-V9.135_ontim.q0mp1.k61v1.64.bsp_P16
Error : Modem didn't started! Unlock not possible!
Error : SPLock identification failed!
>>> Send log and report.log (if exists) to support! Include device info also!
Reconnect Power/Cable!