WITH POWERED OFF PHONE
PRESS AND HOLD VOLUME DOWN THEN CONNECT TO PC
1. Device must be Power off with battery inside
2. Press and Hold VOl-, or some phones requires press and hold VOl- and VOL+ together
3. Insert usb cable
4. Install spd drivers if needed
====================================
- Connection : Flash Mode
- Brand : Tecno
- Model : Tecno Pop 4 (BC2C)
- Process : Reset FRP
====================================
Waiting for device port ...
Port found
Port : [ COM92 : SPRD U2S Diag ]
Handshaking with device ...
Handshake done
Protocol : SPRD3
Sending config : OK
Sending Boot [UAT PRO.boot1] : DONE
Sending Boot [UAT PRO.boot2] : DONE
BootVersion : Spreadtrum Boot Block version 1.1Detected SoC : Unisoc SC7731e
Reseting Frp please wait ...
Reset Frp done
Rebooting device : DONE
UAT PRO : 140.01 | 26 - حزيران - 2022 [ 06:07:08 م ]
Elapsed Time : 47 seconds