[Ashim Ashram]

Originally Posted by ashim ashram

hello, i am working on a135f and i posses 2 pieces. However when i try to connect them the box says emmc dead yet connecting successfully with ufi. I tried changing pc and updating card firmware but to know avail. Please advise accordingly



setting interface to easyjtag2/isp
setting bus width to 1 bit
setting frequence to 36 mhz
cmd pullup level: 1813 mv
cmd active level: 1865 mv
emmc device information :
Emmc cid: 150100303030303030562016061354d1
emmc csd: 902701320f5903fff6db7fe08a40403b
emmc manufacture : Samsung , emmc name: 000000 , hex: 303030303030 , s/n: 20160613 , rev. 0x56
emmc manufacture id: 0x15 , oem id: 0x00 , device type: Bga (discrete embedded) , date: 5/2017
emmc rom 1 (main user data) capacity: 2095982 mb (01ffb6e00000)
emmc rom 2/3 (boot partition 1/2) capacity: 512 kb (000000080000)
emmc rpmb (replay protected memory block) capacity: 128 kb (000000020000) counter: 0 , response: Maybe not clean
emmc permanent write protection: No
emmc temporary write protection: No
extended csd information :
Extended csd rev: 1.5 (mmc 4.41)
boot configuration [partition_config]: 0x00 , boot from: No boot
boot bus config: 0x00 , width 1bit
h/w reset function [rst_n_function]: 0x00, rst_n signal is temporarily disabled
supported partition features [partitioning_support]: 0x03
device supports partitioning features
device can have enhanced technological features in partitions and user data area
partition settings [partition_setting_completed]: 0x00
emmc init completed.

Warning: Maybe your emmc damaged

emmc are unusable.

the emmc name is dc6dmb of a135f