Quote:
|
Originally Posted by dezel System diagnostics passed.
Version 9.74 ready!
[ --- Attach to Phone --- ]
Connecting via Fighter USB Cable...
Powering on the phone...
Baseband chip ID: 0x7100
Protocol version: 3.1
Baudrate = 460800Bd
Sony Ericsson phone detected.
Phone CID: 49
Phone color: Red
Flash certificate: A1_DB2000_49_RED
Trying Red CID49 flash applet...
Sending applet prologue...
Sending applet body...
Time spent entering bootstrap: 1s
Initializing phone hardware...
Applet ID: 050810 0923 NPA1CXC125871_PRODUCTION_ID_LOADER R2B
Flash manufacturer: Intel
Flash ID: 0x890D
OTP Security Level: 1 (Retail)
OTP CID: 49
Sending applet...
Applet ID: 050926 1419 NPA1CXC1250163_SEMC_FLASHLOADER R2A
RSA protection state cannot be determined for this CID.
Phone hardware initialized OK
[ --- Flash Main Firmware --- ]
Flash file: "K600i_CXC1250014_Europe1_R2BA019.ck6sw"
Waiting for flash file to load...
Preparing to program flash...
Defeating RSA protection...
Waiting for the phone to turn off...
Should the communication hang, reinsert battery.
Baudrate = 460800Bd
Sending applet prologue...
Sending applet body...
Waiting for acknowledge...
This may indicate damaged EROM area!
Try repairing the phone via testpoint method.
If it is an old phone, try converting it to brown first.
Script error: Unspecified [9.74.41]
(of course i unlock RSA first)
any idea???
dezel |
Older phones with unlocked EROM area:
· Connect the phone to the cable and select Normal boot.
· Attach Cruiser to the phone.
· Go to the Security RSA page and replace the certificate by Brown CID49. Remove battery when asked by Cruiser. If this process fails, the phone has a locked-down EROM area and therefore it cannot be converted to Brown CID49.
· Now press the Direct Unlock button.
Newer phones with locked-down EROM area:
· Be sure to have installed the latest Cruiser firmware restoral package from our support area.
· Connect the phone to the cable and select Normal boot.
· Attach Cruiser to the phone.
· Go to the Security RSA page and press the Unlock RSA button. Remove battery when asked by Cruiser.
This will overwrite part of main firmware by special code thus causing the phone to appear "dead".
· Reinsert the battery and reattach Cruiser to the phone.
· Go to the Security RSA page and press the Restore firmware button. Cruiser will search for a restore file then. If it cannot be found, you will also have to reflash main FW and raw FS and to customize the phone.
· Now go to the Locks page and press the Direct unlock button. Remember, if you encounter any new firmware it is wise to make a security zone backup too (or a full GDFS backup).
Note: You may use the Ctrl-A key combination to attach the phone and the Ctrl-O key combination to turn the phone off.