@ GsmOrient,
Please run Prepare cycle exactly as written in
manual.
Log file should be like this one:
Quote:
Switching to flash mode... OK
Reading phone boot version... A.30
Sending boot... OK
Erasing flash memory OK
Sending firmware OK
Searching for phone... found S Blank Neptune LTE2
Switching to flash mode... OK
Reading phone boot version... 3.00
|
About Clip Communiacation error: In case of getting an error "Clip communication failed", while detecting the handset, please check the output of Smart-Clip power source. For stable Smart-Clip functions minimum output is 9V & 500mA. Recommended power supply is 12V & 750mA.
Some phone models use a data cable for charging. So, as soon as it gets connected to Smart-Clip it starts charging and uses about 500mA, plus Clip requires another 130-150mA.
V3 with boot 8.29 can be done via TP.
Best Regards
Smart-clip team
www.smart-clip.com www.GsmServer.com www.boot-loader.com www.smart-unlocker.com