First make shure power adaptor is ok ... about 9V
Second check update cable ...
I have find out that some update cables are not ok.
You can find update cable schematics + update software here ....
http://www.gsmnews.net/nklip/update.rar
To update you need standard interface ( like UNIBOX, FOURIOUS, INFINITY, POLAR etc... try to find one of these ... )
This is 100% correct:
1. Start Update software
2. Select appropriate COM Port
3. Press the clip button and keep pressing
3. Put update cable intro CLIP and into interface ( keep pressing the button )
4. Put power to the clip ( keep pressing button ) ( DCT3 and DCT4 leds must be inactive if all is ok if not try again from step 3 after you remove power and update cable...)
5. Press update in Update Software ( after you select correct update pack )
6. Wait until update begins (1-5 seconds)
7. Release button ...