Quote:
Originally Posted by candra_yus  hi, i just purchase tornado infra handheld from one of reseller in indonesia, i've question to ask mr gobi or mr ren:
1. how much exactly temp that it work to pick up connector, glued ic?coz last time i pick up the batt connector, the tornado damage the connector(e.x. in dct4+ board like 1110,1600,etc)
2. i only purchase the handheld without the preheater, does it mean so much for the result?can i combine it with lukey preheater?
thx for the answer
P.S. the temp that i use is 30.65! |
@candra_yus
For the battery connector, you should put some good flux to decrease the melting point, and set the temperature to around 30 on your handheld station. Too much temperature can burn the pcb, so start from low first.
For glued ic and lead free PCB's, a preheater is a must. This is to preheat the pcb first with temperature around 100 degrees C before you rework using the the handheld station.
More practice on how to use it can achieve better results.
For more technical info's you can contact or pm me here.
regards,
ren