[puneet14884]

Originally Posted by mobilagy

Again here the most simplest Nokia N70 blank LCD (non complete booted) solution; just if the problem is limited with APE regulator & SYNC/MODE SW .

If APE regulator is damaged or rusted then apply jumper 1 .
If SYNC/MODE SW is damaged or rusted then apply jumper 2 .
If both or for not wasting time then apply both jumpers .
& The advantage here is both jumpers can be made with a bit solder no need for wiring as both two jumper points are so closed.

Otherwise, it may be APE combo flash IC or processor OMAP fault (unsoldered or damaged) .

GΟD bless it >>>

By puneet1484, shot with N90-1 at 2007-07-22