| today i'm try another i-mobile CE0889 but when i power on it show only logo after off
log here
COM10 [VCP0] selected
Device: I-Mobile CE0889
Checking data, wait...
advanced flash detection enabled
Action: reset
Boot...
Press and HOLD Power button now !
baud autodetection active
19200 autodetect
Connecting, wait...
Initializing[6226:8A02:8A01]...
CPU: MT6226
chip: 0031:8941:9754
boot step size: 0400
Release Power button now !
Boot Done
Initialize...
detecting chip #00 in region #00...
flash: 98004900000002:29EA0000000000
flash: Toshiba AMD/Fujitsu std [T 0008x002000 00FFx010000] 16Mb
number of flash chip/regions detected: 01/01
Initialize Done
Set baud...
921600
Set baud Done
Initialize bootcode...
Initialize bootcode Done
Check firmware integrity...
detect device identification#1...
detection phase #1...
detect device identification#1 finished
identification#1 structure: 2nd [standard] generation
identification#1 protocol ver: 04
ver. sw1: ARIMA26_05C_PCB01_GPRS_MT6226_S01.7S-7311-INS0-0-R1B-3.BIN
ver. sw2: 7S-7311-INS0-0-R1B-3, 00000000
ffs offset/size: 00E00000/00200000
detect device identification#2...
detection phase #1...
.
warning: optional information not found,
if phone works well just ignore this warning
detect device identification#2 finished
Check firmware integrity Done
Check firmware content...
Check firmware content Done
Backup required data...
flash: 98004900000002:29EA0000000000
Backup required data Done
Patch required data...
Patch required data Done
Special operation...
Special operation Done
Write...
Write Done
Finalization...
formatting...
flash: 98004900000002:CED27D00000000
Finalization Done
Finished, time used: 24 sec
Remove/Install battery now !
File system has been modified !
It is need to press and HOLD phone "Power" button
during long time (up to 1 min) to make phone Powered-On ! |