Quote:
Originally Posted by FullFLASHgSMPH  tested 1000%
1. Open phone and cut track according to test-point picture in “Documentation” folder
2. Now phone can’t power-on but can be connected to software and unlocked/flashed in “Repair mode”
3. If phone still can power-on with cutted track this means that:
3.1. Track cutted not correctly, double check that track cutted well and continue with instruction below:
3.2. New phone PCB type, need to desolder CPU, remove ball “N1” and continue with instruction below:
4. Run “Moto02” module (ver 1.25 or higher)
5. Go to “Settings” page and make “Repair mode” connection box checked
6. If you don't want to restore cutted track back after repair procedure make "Soft restore" cutted track option checked
7. Optional step: make flash backup (read flash) for emergency case
8. Flash phone with the next flash files from support area (letter x means any):
1.x.xx
2.0.xx
2.1.xx
9. Optional step: make "sp-unlock" operation
10. Restore track back (if "Soft restore" cutted track option was not checked during flash operation) |
cut track only good for old version, here is latest version thread and N1 ball removal needed.