GSM-Forum - View Single Post - L6 Dead, Keypad light turns on for 5 sec.

Ayush · 10-30-2008, 14:25

Hi,

I've been trying to fix L6, which upon being powered on brings up keypad backlight for 5 seconds and then again goes off. Tried almost all the flash files from the download section, fixed the boot loader, pds, IMEI, still all in vain. Can't understand what the problem could be.

Here is the log..

SmartMoto 3.17
S-Card: xxxxxxxxx Smart-Clip dongle, v 2.10, assigned Smart-Clip: xxxxxxxxxxxx Europe, initializing... OK
Clip serial: xxxxxxxxx, version: 4.08, initializing... OK
Searching for phone... found S Flash Neptune LTE, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 8.D0
Sending boot... OK
Erasing flash memory OK
Sending firmware OK
Searching for phone... found S Flash Neptune LTE
Switching to flash mode... OK
Reading phone boot version...
io timeout

Searching for phone... found S Blank Neptune LTE, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 2.00
Reading flash id... ST - M30L0R8000B0
Phone group: A630,E1,E37x,E39x,E55x,L6,U6,V3,V190,V330,V53x,V54 x,V55x,V62x,V635,V80
Hardware IMEI: xxxxxxxxxxxxxxxxx
IMEI OTP status: locked
Security area saved to "PDS for S Blank Neptune LTE xxxxxxxxxxxxxxx.mbk"
Login request... OK
Writing flash section 4 of 4... 100% (11.5 Kb/sec)
Restarting phone... OK
Searching for phone... found S Blank Neptune LTE
Switching to flash mode... OK
IMEI OTP status: locked
Repair PDS request... OK
Performing PDS repair... OK
Writing flash section 1 of 1... 100% (19.6 Kb/sec)
Please write a corresponding Full_flash file to phone to complete repair
Writing flash section 2 of 2... 100% (60.3 Kb/sec)
Flash completed!
Applying IMEI patch, please wait (up to 2 minutes!)... OK
IMEI patch successfull, set new IMEI with the "Write" button
Writing new IMEI xxxxxxxxxxxxxxx... OK
Turning phone off... OK

As it can be seen from the log, I did the following :
1. PDS Repair
2. Write Full Flash including boot area
3. Repari IMEI

This usually works for almost all the phones. Strange it ain't working for this one. I've all reasons to belive this maybe a hardware problem, but can't square on the fault.

Any ideas?

Thnx
Ayush

P.S. - With some flash files, the keypad light blinked for 20 seconds. I replaced the flash but still the same.

10-30-2008, 14:25	#1 (permalink)
Ayush Freak Poster Join Date: Dec 2002 Age: 39 Posts: 292 Member: 18577 Status: Offline Thanks Meter: 4	L6 Dead, Keypad light turns on for 5 sec. Hi, I've been trying to fix L6, which upon being powered on brings up keypad backlight for 5 seconds and then again goes off. Tried almost all the flash files from the download section, fixed the boot loader, pds, IMEI, still all in vain. Can't understand what the problem could be. Here is the log.. SmartMoto 3.17 S-Card: xxxxxxxxx Smart-Clip dongle, v 2.10, assigned Smart-Clip: xxxxxxxxxxxx Europe, initializing... OK Clip serial: xxxxxxxxx, version: 4.08, initializing... OK Searching for phone... found S Flash Neptune LTE, getting test interface... interface not found Switching to flash mode... OK Reading phone boot version... 8.D0 Sending boot... OK Erasing flash memory OK Sending firmware OK Searching for phone... found S Flash Neptune LTE Switching to flash mode... OK Reading phone boot version... io timeout Searching for phone... found S Blank Neptune LTE, getting test interface... interface not found Switching to flash mode... OK Reading phone boot version... 2.00 Reading flash id... ST - M30L0R8000B0 Phone group: A630,E1,E37x,E39x,E55x,L6,U6,V3,V190,V330,V53x,V54 x,V55x,V62x,V635,V80 Hardware IMEI: xxxxxxxxxxxxxxxxx IMEI OTP status: locked Security area saved to "PDS for S Blank Neptune LTE xxxxxxxxxxxxxxx.mbk" Login request... OK Writing flash section 4 of 4... 100% (11.5 Kb/sec) Restarting phone... OK Searching for phone... found S Blank Neptune LTE Switching to flash mode... OK IMEI OTP status: locked Repair PDS request... OK Performing PDS repair... OK Writing flash section 1 of 1... 100% (19.6 Kb/sec) Please write a corresponding Full_flash file to phone to complete repair Writing flash section 2 of 2... 100% (60.3 Kb/sec) Flash completed! Applying IMEI patch, please wait (up to 2 minutes!)... OK IMEI patch successfull, set new IMEI with the "Write" button Writing new IMEI xxxxxxxxxxxxxxx... OK Turning phone off... OK As it can be seen from the log, I did the following : 1. PDS Repair 2. Write Full Flash including boot area 3. Repari IMEI This usually works for almost all the phones. Strange it ain't working for this one. I've all reasons to belive this maybe a hardware problem, but can't square on the fault. Any ideas? Thnx Ayush P.S. - With some flash files, the keypad light blinked for 20 seconds. I replaced the flash but still the same.