COM14 [VCP3] selected
module v2.70
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
eeprom backup enabled, it may takes several minutes !
Action: repair "bad software" (mode-2)
Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6225:8A03:8A00]...
CPU: MT6225
high speed boot On
chip: 0001:0B03:000D
boot packet size: 0400
Release Power button now !
Boot Done
Initialize ...
detecting chip #00 in region #00...
flash: EC257E25082501:18E59F00000000
flash: Samsung AMD/Fujitsu std [D 0008x002000 00FEx010000 0008x002000] 16Mb
detecting chip #01 in region #00...
flash: EC257E25082501:18E59F00000000
flash: Samsung AMD/Fujitsu std [D 0008x002000 00FEx010000 0008x002000] 16Mb
number of flash chip/regions detected: 02/01
Initialize Done
Set baud ...
230400
Set baud Done
Initialize bootcode ...
Initialize bootcode Done
Check firmware integrity ...
device parameters autodetection in progress...
detecting chip #00 in region #00...
flash: EC257E25082501:18E59F00000000
flash: Samsung AMD/Fujitsu std [D 0008x002000 00FEx010000 0008x002000] 16Mb
detecting chip #01 in region #00...
flash: EC257E25082501:18E59F00000000
flash: Samsung AMD/Fujitsu std [D 0008x002000 00FEx010000 0008x002000] 16Mb
it's time to stop: 18F09FE518F09FE518F09FE518F09FE518F09FE518F09FE5
number of flash chip/regions detected: 01/01
total flash region size: 01000000
detect device identification#1...
detection phase #1...
detect device identification#1 finished
identification#1 structure: 2nd [standard] generation
identification#1 protocol ver: 04
ver. sw 1: MTK25_GEMINI_PCB01_GPRS_MT6225_S00.A522-ZSPIDER_8G-2_G-CAM_MY_146_081014.BIN
ver. sw 2: A522-ZSPIDER_8G-2_G-CAM_MY_146_081014, 00000000
ffs offset/size: 00E00000/00200000
detect device identification#2...
detection phase #1...
.
warning: optional information is not found,
if phone works well just ignore this warning
detect device identification#2 finished
detecting firmware protection...
detecting firmware structure #8...
phase #1...
.................................................. ..............
phase #2...
.................................................. ..............
done
error: firmware protection firmware structure #8 is not found
What to do:
1. Be sure that your phone really has "bad software" problem, in other case do NOT use "bad software" button !
2. Repeat "bad software" operation several times to avoid communication problems.
3. Flash phone with firmware from support area and repeat "bad software" operation.
If still no luck:
1. read full flash and send to support:
[email protected]
2. send "operation.log" file to support:
[email protected]
error: autodetection failed
Finished, time used: 51 sec
Remove/Install battery now !