GSM-Forum - View Single Post - MML Failure at 'Waiting for full connect...' Red LED Flashing Twice

sandos71 · 08-25-2009, 21:33

Hello... I'm hoping someone can pop in here with some help for me possibly. I have successfully unbranded, unlocked, rebranded a few BB Bolds and 83XXs. This morning I was attempting to unbrand a warranty replacement Bold and I ran into a problem I've never seen before. Following the status quo instructions, MML will do it's magic with the auto start on, full erase off, however when it reaches the point where I am supposed to have the white OS screen and FAIL on MML, I get the FAIL on MML but I have a black screen with the LED pulsing twice about every 5 seconds. When I enter the menu to attempt to clear the MEP and load the VSM I get an error saying something like MML can't connect to the radio. The device also seems to have all zeros for it's PIN. So, my only way out of this is to pull the battery and reload the OS, which works fine and restores the PIN, however when I attempt again with MML I run into the same problem. I thought I might have needed a bit more charge in the battery so I let it get to 85% and still the same problem. Anyone have any suggestions please? Thank you.

08-25-2009, 21:33	#1 (permalink)
sandos71 Junior Member Join Date: May 2009 Posts: 12 Member: 1036971 Status: Offline Thanks Meter: 1	MML Failure at 'Waiting for full connect...' Red LED Flashing Twice Hello... I'm hoping someone can pop in here with some help for me possibly. I have successfully unbranded, unlocked, rebranded a few BB Bolds and 83XXs. This morning I was attempting to unbrand a warranty replacement Bold and I ran into a problem I've never seen before. Following the status quo instructions, MML will do it's magic with the auto start on, full erase off, however when it reaches the point where I am supposed to have the white OS screen and FAIL on MML, I get the FAIL on MML but I have a black screen with the LED pulsing twice about every 5 seconds. When I enter the menu to attempt to clear the MEP and load the VSM I get an error saying something like MML can't connect to the radio. The device also seems to have all zeros for it's PIN. So, my only way out of this is to pull the battery and reload the OS, which works fine and restores the PIN, however when I attempt again with MML I run into the same problem. I thought I might have needed a bit more charge in the battery so I let it get to 85% and still the same problem. Anyone have any suggestions please? Thank you.