Quote:
Originally Posted by pentu seba
the photos are for everyone to see.
Profile - Lead
x1-100C
UH-reflow
LH-reflow
x2-140c
UH- fast reflow
LH-reflow
x3-182c to 185c
UH- reflow
LH-fast reflow
Profile - Lead Free
x1-100C
UH-reflow
LH-reflow
x2-140c
UH- fast reflow
LH-reflow
x3-215c to 218c
UH- reflow
LH-fast reflow
the temperature rises +3c to 5c, so chose the x3 setting according to your jovy machine errors (how much the temp spikes after the profile is completed).
Do not move the upper heater to parking mode after the profile is completed, wait for five to seconds then move the upper heater to parking mode while reflowing. when removing the IC move the upper heater immediately after removing the IC.
this profile settings are working for me , pls work on junk boards and check the profiles efficiency & do not blame me if it fails, i am just trying to help you.
B/R |
New to this forum.
I burnt one board already with Jovy now i have found your profile & will use it. I am sure to get result. Can you please tell me if I should add Flux before starting preheat or after the preheat is complete. Thanks