Quote:
Originally Posted by bhartek New to this forum.
I burnt one board already with Jovy now i have found your profile & will use it. I am sure to get result. Can you please tell me if I should add Flux before starting preheat or after the preheat is complete. Thanks |
Apply flux before placing pcb on the x,y table, if possible apply flux and use hot air ****er to **** flux below the bga (dont use too much of heat), this method ensures wetting of the solder balls properly. after the reflow process, clean with DI water or IPA it depends which type of flux you use (you can use even good quality thinner, some people wont agree with me), my advice is use Interflux Belgium IF8300 BGA flux gel, it is very good.