w995 siroko connection erro r
error: boot phase#1 failed
Need solution Infinity Team
Code:
COM3 [VCP0] selected
module v3.07
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
Action: reset settings ("format ffs")
ffs/eeprom backup enabled, it may takes several minutes !
====> Boot ...
Press and HOLD Power button now !
baud autodetection active
9600 autodetect
Connecting, wait...
error: boot phase#1 failed
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect"
Boot Fail
Finished, time used: 2 sec
Remove/Install battery now !
Quote:
COM3 [VCP0] selected module v3.22
Action: reset settings ("format ffs")
Model: Autodetect 6205-6239 NOR
Checking data, wait...
Phone should be Switched OFF !
Press and HOLD Power button now !
9600 autodetect
error: boot phase #2/1 failed
Can not initialize test mode, possible reasons:
1. communication fault, repeat required operation
2. ffs/eeprom is seriously damaged, use repair ffs/eeprom files or use another unlock/format method
error: operation failed !
Finished, time used: 8 sec
Remove/Install battery now !
|