GSM-Forum - View Single Post

tonywireless · 10-26-2010, 00:00

hi mr moderators and other experienced members pls i have a problem flashing china e97 ,it was detected successfully by the pin finder , but when i try to flash on the infinty software it gives me an error message log is below,how can i fix this problem then?

COM17 [VCP0] selected
module v3.24
Device: Autodetect 6205-6239 NOR
Checking data, wait...
advanced flash detection enabled
Action: reset settings ("format ffs")
ffs/eeprom backup enabled, it may takes several minutes !
====> Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6235:8A04:8A01]...
CPU: MT6235
high speed boot On
chip: 0000:0000:0003
status: FF
boot packet size: 0400
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect"
Boot Fail
Finished, time used: 11 sec
Remove/Install battery now !

10-26-2010, 00:00	#1 (permalink)
tonywireless No Life Poster Join Date: Apr 2009 Posts: 988 Member: 1012165 Status: Offline Thanks Meter: 116	help problem flashing china e97 hi mr moderators and other experienced members pls i have a problem flashing china e97 ,it was detected successfully by the pin finder , but when i try to flash on the infinty software it gives me an error message log is below,how can i fix this problem then? COM17 [VCP0] selected module v3.24 Device: Autodetect 6205-6239 NOR Checking data, wait... advanced flash detection enabled Action: reset settings ("format ffs") ffs/eeprom backup enabled, it may takes several minutes ! ====> Boot ... Press and HOLD Power button now ! 19200 fixed Connecting, wait... Initializing [6235:8A04:8A01]... CPU: MT6235 high speed boot On chip: 0000:0000:0003 status: FF boot packet size: 0400 Release Power button now ! in case of initial connection problem: on/off "Boot baudrate autoselect" Boot Fail Finished, time used: 11 sec Remove/Install battery now !