Done! :-)
It's the Not Connected, and the black one
Thanks for sharing the info, it works great!
Quote:
Originally Posted by PimVB I have a Micro-B connector cut from a usb cable, which pin must I use?
1 = Red (VCC)
2 = White (Data -)
3 = Green (Data +)
4 = ID (Micro-B not connected)
5 = Black (GND)
So if pin 4 (ID) is not connected, where do I put the resistor?
If I stripped the connector, I see under: black, green and red and top: white and one that is not soldered.
So it is pin 5 (black) with the one that is not soldered?
Sorry for the noob question ;-) |