GSM-Forum - View Single Post

tinner105 · 11-18-2010, 02:37

I traced down this on two different 3gs's with no backlights.
I have a couple questions for the smarter than me guys.
Looking at the Pict. with the backlight paths.... from this post
should there be any continuity across the yellow rectangular
thing that feeds the #2 pin on the connector?
And on both of my phones the smaller version of that below the coil....
i have no continuity from the left side to the coil above it.
But i do from the right side of it. And again theres no continuity across the little block its self.

1. Is there supposed to be continunity across the yellow rectangular pieces?

Thanks
tony

11-18-2010, 02:37	#3 (permalink)
tinner105 Freak Poster Join Date: Jul 2010 Location: California Posts: 243 Member: 1352483 Status: Offline Thanks Meter: 24	I traced down this on two different 3gs's with no backlights. I have a couple questions for the smarter than me guys. Looking at the Pict. with the backlight paths.... from this post should there be any continuity across the yellow rectangular thing that feeds the #2 pin on the connector? And on both of my phones the smaller version of that below the coil.... i have no continuity from the left side to the coil above it. But i do from the right side of it. And again theres no continuity across the little block its self. 1. Is there supposed to be continunity across the yellow rectangular pieces? Thanks tony