| Log Here
COM2 [VCP0] selected
module v3.62
Device: Micromax-Q5
Checking data, wait...
Action: write flash NAND
write: Firmware
Micromax-Q5_TINNO35_09A_PCB01_GPRS_MT6235B_S01.E521_MP_F1_I N_MMX_05_09_2010-03-01_En.B4M.bin
skip: Customization/Language Pack
skip: Customization
skip: Eeprom/ffs
nfi area detection...
bootloader version: TINNO35_09A_BOOTLOADER_V005_MT6235B_E521_MP_F1_IN_ MMX_05_09.bin
nfi area detection (3 cores) finished: Ok
interface: BROM_DLL_v3.1016.00
Connect...
Phone should be Switched OFF !
Press and HOLD Power button now !
Connecting...
Booting...
Release Power button now !
bootcode current/expected: 3.2/3.2
CPU: 6235:8A04:8A01
status: FF
bbchip bl ver: FE
NOR flash chip: not installed
NAND flash id[0017]: 00AD:007600AD0076 [HYNIX] HY27XS08121M
chip size: 64Mb
page/spare size: 0200/0010
pages per block: 0020
bits i/o: 08
address cycles: 04
internal RAM size: 00010000
external RAM: S_DA_RAM_ERROR
done
Set baudrate (921600)...
done
ram test...
testing...
ram test passed
===> detect existing firmware structure...
detect ffs...
detect sec ro...
detect custom parameters...
detect project-id...
detect NAND info...
number of areas/bytes to read: 1:00034000
reading (HW_STORAGE_NAND NUTL_READ_PAGE_ONLY)...
nfi area detection...
warning: header is empty: probably flash chip completely erased
warning: can not detect header
nfi area detection (0 cores) finished: failed
warning: ffs can not be detected
TCL-ID detection...
TCL-ID detection done
startup code area #1 detection...
startup code area #1 detection done
code offset: 00000000
===> done
nfi area detection...
bootloader version: TINNO35_09A_BOOTLOADER_V005_MT6235B_E521_MP_F1_IN_ MMX_05_09.bin
nfi area detection (3 cores) finished: Ok
startup code area #1 check...
startup code area #1 calculation...
startup code area #1 fixed
number of cores: 3
loading files...
number of areas: 3
done
write...
write bootloader...
.
.
write core...
Disconnect...
done
Finished, time used: 7 min 48 sec
Remove/Install battery now ! |