| If phone does not turn on after flash or if stop during flash procedure than u must perform "reset" procedure, this procedure will also unlock your phone and user must do same procedure as follows.
CID 50,51,52,53
that is so-called reset procedure.
1. go to emptyboard tab
2. select proper model
3. on settings, check "signed mode"
4. press recovery
5. after succeful recovery
6. on settings uncheck all
7. add to firmware area propergdfs in ssw format
8. add to firmware area proper EROM (EROM CID >= OTP CID)
9. press flash
10. if needed,reflash phone on usual semc tab with needed settings.
Last edited by mobile mart; 07-17-2011 at 18:26.
|