View Single Post
Old 07-21-2011, 07:04   #1353 (permalink)
vino_89
Freak Poster
 
vino_89's Avatar
 
Join Date: Dec 2008
Location: Manila
Age: 14
Posts: 157
Member: 935830
Status: Offline
Thanks Meter: 157
Cyon KU9500 too many pattern attemp sulotion in Octopus suc

KU9500 too many pattern attemp!!!
no other sulotion......

problem solve by flashing

Welcome to Octopus box software version 1.8.2
--------------------------------------------------------------------------------
Platform: LG Qualcomm
Selected port: COM162
Selected model: KU9500
Mode: Normal
Phone model: KU950014
SW Version: 8650B-SDCAOLYM-407705
IMEI: 352527-04-023927-5
Bluetooth address: 5C:173:3C:71:8B
Firmware compiled date: May 31 2010
Firmware compiled time: 24:00:00
Firmware released date: Nov 11 2010
Firmware released time: 20:35:53
--------------------------------------------------------------------------------
Platform: LG Qualcomm
Selected port: COM162
Selected model: KU9500
Mode: Normal
Phone model: KU950014
SW Version: 8650B-SDCAOLYM-407705
IMEI: 352527-04-023927-5
Bluetooth address: 5C:173:3C:71:8B
Opening "KU950023_00.oct"...OK
--------------------------------------------------------------------------------
Please, make sure the phone's battery is fully charged.
Disconnect all other devices from the computer (including phones,
modems, etc.) and close all other running programs. To avoid errors
in the flashing process, use a clean PC (without any installed drivers
for other Qualcomm-based devices). You should not run any other
programs or attach new devices to your computer during the
flashing!

Please, follow these simple precautions to avoid damaging your
phone.
--------------------------------------------------------------------------------
Reading NVM...OK
Backup saved to "KU9500-352527040239275_21-07-2011_09-53-
41.nvm"
Switching to Download mode...OK
Testing connection...OK
Writing Firmware...
Writing AMSS...OK
Writing APPSBL...OK
Writing DSP1...OK
Writing EFS2...OK
Writing WEBDOWN...OK
Writing LNX-boot...OK
Writing LNX-cache...OK
Writing LNX-recovery...OK
Writing LNX-system...OK
Writing LNX-userdata...OK
Finalizing...OK
Phone startup...
--------------------------------------------------------------------------------
To continue writing do next:
1. Diconnect cable from phone
2. Power phone ON
3. Connect cable to phone
--------------------------------------------------------------------------------OK
Writing NVM...OK
Rebooting phone...

special tnx to sir octopus..

wbr,
vino_89
  Reply With Quote
The Following 2 Users Say Thank You to vino_89 For This Useful Post:
 
Page generated in 0.06866 seconds with 7 queries