GSM-Forum - View Single Post

mobymaster · 07-01-2004, 16:00

Hi,

I received today my dongle and test boxes from completegsm.

Worked fine on unlocking myx2s, then I tried a myv65 on.

Connected all up, np. Went to detect phone Np, and then went to unlock but "reboot phone". I checked the pcb for dirt/glue and there was nothing on the board, checked the test point adapters were not jammed and they were fine.

When it was connected, i noticed that the test point going to DB9.2 is 1mm off the actual point and is touching the pcb.

I put a bit of solder on the point and trailed it off, and it worked.

Has anyone else experienced these problems? Or is it a one off case?

Thanks in advance
John

07-01-2004, 16:00	#1 (permalink)
mobymaster Freak Poster Join Date: Jul 2002 Location: Manchester, UK Posts: 259 Member: 13975 Status: Offline Thanks Meter: 7	Test Jig on MyV65 Hi, I received today my dongle and test boxes from completegsm. Worked fine on unlocking myx2s, then I tried a myv65 on. Connected all up, np. Went to detect phone Np, and then went to unlock but "reboot phone". I checked the pcb for dirt/glue and there was nothing on the board, checked the test point adapters were not jammed and they were fine. When it was connected, i noticed that the test point going to DB9.2 is 1mm off the actual point and is touching the pcb. I put a bit of solder on the point and trailed it off, and it worked. Has anyone else experienced these problems? Or is it a one off case? Thanks in advance John