07-25-2004, 17:10
|
#6 (permalink)
|
Freak Poster
Join Date: May 2001 Location: Philippine/Bermuda Age: 49
Posts: 335
Member: 4691
Status: Offline
Thanks Meter: 42 | Quote:
Originally Posted by dannyogolo Hello Ericsson Hardware Experts,
After many searches here, I realised that to repair NO ACCESS / NO NETWORK on Ericsson
(I have heard even also SonyEricsson) phones, the RF PA has to be changed. OK
I have done so on 4 Ericsson phones: T20, T28e, T29s, R320, but to my surprise, they
all still show the same "NO ACCESS or NO NETWORK" !!!
The PA I used was brought in from Dubai and they were Tagged T28 PA
Numbers on PA:
RM009-10P
E38666_1
0024
MEXICO
I am sure of my job, I solder them very neatly with Rework Station, this is since the
phones come on.
So now what seems to be the problem?
This is a challenge to us all !!!
Am I using a fake PA, or is it that PA is not the fault?
Every Ericsson Expert, lets face it.
Starting with you. |
Sir, u just missed sumthing u must change also ur RF pre amps becoz when u change P.A. it will result into low sensitivity in ur RX dats why the phone can't see networks...Hope this helps u |
| |