GSM-Forum - View Single Post - Iphone hardware and software solutions in 24 hrs

Sillyboy4 · 12-08-2011, 21:41

I have a water damage iphone, first problem is that there is 0 Ohm between battery socket + and -, i think i don't have to say it turns on only on charger.

The second problem, a man in a service tried DFU and recovery but without the battery... It's stuck in revovery btw until the emergency call window showed up it said there is no IMEI and couldn't find any service.

How can i tell where is the short on the board? I put it on charger but every part was cold. This method works only with a source on the battery socket?
And the basebend problem is because of the battery or i have to repair the battery problem then the IMEI problem too?
Thanks!

12-08-2011, 21:41	#2076 (permalink)
Sillyboy4 Junior Member Join Date: Dec 2011 Posts: 10 Member: 1702322 Status: Offline Thanks Meter: 1	Iphone 4 'not charging' I have a water damage iphone, first problem is that there is 0 Ohm between battery socket + and -, i think i don't have to say it turns on only on charger. The second problem, a man in a service tried DFU and recovery but without the battery... It's stuck in revovery btw until the emergency call window showed up it said there is no IMEI and couldn't find any service. How can i tell where is the short on the board? I put it on charger but every part was cold. This method works only with a source on the battery socket? And the basebend problem is because of the battery or i have to repair the battery problem then the IMEI problem too? Thanks!