12-30-2011, 16:13
|
#2 (permalink)
|
No Life Poster
Join Date: Sep 2008 Location: Just Imagine Age: 42
Posts: 4,263
Member: 1191481
Status: Offline
Sonork: 1592603 Thanks Meter: 1,373 | Quote:
Originally Posted by 7seas Sir, its ok that some ver. of zte c201 not directly unlockable, but what is this when i connect with infinity-box and readinformation it reads:
---------------------------------------------------------
HARDWARE : RIC_
COMPILE : Jul 31 2006 (17:09:26)
REALEASE : Dec 03 2004 (12:00:00)
SW Version : dbgprintf gBI
---------------------------------------------------------
ESN(hex) : 08F42623
ESN(hex) : 08F42623
Phonce code : 0000
Finished, time used: 5 sec
BUT when i give unlock :
COM3 [VCP1] selected
module v1.70
Device: ZTE-C201, C202, C203, C204
operation: SP-unlock
Phone should be Switched ON !
connecting...
checking diag mode...
check cable
Finished, time used: 10 sec
WHAT IS THE PROBLEM ? Where m i making mistake?
after that i select c205 model in infinity and gave unlock results:
COM3 [VCP1] selected
module v1.70
Device: ZTE-C205
operation: SP-unlock
Phone should be Switched ON !
connecting...
wait conecting...
Calculating spc based on esn...
OFFLINE...
ESN(hex) : 08F42623
ESN(dec) : 00816000547
trying to sending spc based on esn method 1...
SPC:91818066
wrong spc
wait reconecting in 10 sec..
trying to sending spc based on esn method 2...
SPC:149230
Right spc
disabling minlock...
Done...
enable RUIM...
Done...
Phones should be restarting now...
Finished, time used: 18 sec
that was just RnD, but phone not unlocked.But my question is Why it shows checking diag mode...
check cable? | Hello,
Power Off Phone Power On Phone And Do Spunlock When Phone Starting
Wbr
<<<Megatron>>> |
| |