Its Standard 9 Pin Connection Just Below Sim Connector..
1 VCC, 2 TMS, 3 RTCK, 4 TRST, 5 TDI, 6 TCK, 7 TDO, 8 NRST, 9 GND
Code:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.42
Selected Resurrector: [Samsung B209 V1.00]
Connecting to the dead body...OK
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Detected dead body ID: 0x100FA0E1
Code:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.42
Selected Resurrector: [Samsung B209 V1.00]
Connecting to the target...OK
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x100FA0E1, IR Length = 0x04 bits
Total IR length: 0x0004 bits
Code:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.42
Selected Resurrector: [Samsung B209 V1.00]
Halting target...OK
STATUS: Target is halted.
R0 = 0x00240201 R6 = 0x0000000C R12 = 0x00000001
R1 = 0xFBF06040 R7 = 0x0486C54C R13 = 0x008D6920
R2 = 0xFBF06000 R8 = 0x00000000 R14 = 0x00000015
R3 = 0x0001B000 R9 = 0x00000000 R15 = 0x001FE50C
R4 = 0x0000FC4C R10 = 0x00000000 CPSR = 0x400000B0
R5 = 0x00000001 R11 = 0x00000000
Code:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.42
Selected Resurrector: [QSC6XXX 32/08 M01D1 NAND V1.00]
Connecting to the dead body...OK
Detected dead body ID: 0x100FA0E1 - CORRECT!
Set I/O Voltage reads as 1.95V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Settings Code: 0x25010000000000000000000008000000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected a Not Initialized FLASH1 Chip, ID: 0xAAAA/0xAAAA (256MB)
ERROR: Selected FLASH1 Chip was not Recognized by the DCC Loader. Terminating.
Processor:
QSC6075
Memory IC:
SEC 031BL60
K5W2GHACF
Which Dll to select for reading full dump??
PS: Set is Blinking on Samsung Logo, Can be flashed in emergency mode too, but still stucked at samsung logo..
Thanks