06-13-2012, 21:12
|
#1 (permalink)
|
| Freak Poster
Join Date: Mar 2009
Posts: 170
Member: 989106
Status: Offline Sonork: kucing Thanks Meter: 29 | samsung sph-d710 resurection error
samsung sph d710 dead after instal custom rom error resurection Code: Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [Samsung SPH-D710 V1.0.4514.6533]
Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.79V, TCK Frequency is 4 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0001 (MAG4FA, 0x0003AB400000 Bytes = 14.68 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0001 (MAG4FA, 0x000000080000 Bytes = 0.50 MB)
Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x010000) Try for make erase....
erase complete,but when try resurection, problem still same
is there some one have a full dump for this model....
i wan try for write full dump.........
|
|
|  |