i have phone cross f3 with lock code..i try to factory set with MCN and its done but the phone dead..
i didn"t back up the firmware thats my fault,but my question why my phone dead only with factory set..?
anybody have cross F3 firmware please??
Code:
Welcome to use McnBox!
Selected COM5
Baud setting ...
Set Baud done
Initialize in progress ...
Checking data ...
Serial No. MCN2010xxxxxxxxx
Firmware V1.15
Checksum 3385-1DBE
Software V3.33
Box Connected!
Ready working at COM5
Scanning pin status,please waiting...
->
Pin-status Scan Done
-------------------------------
Start Scanning...
->
User Abort
Pinout has been cleared
Scanning pin status,please waiting...
->
Pin-status Scan Done
Scanning,waiting...
->
Operation done, Pin detect out.
BOOT£º1
USB D-: 3 USB D+: 4 VID:4305&PID:46B3
Press [ Save ] to save Pinout
Total expend 27 seconds
[G:8 9 D-:3 D+:4 Up:1] Apply to Box
If Scan other phone, please click [Stop]
Scanning,waiting...
->
Operation done, Pin detect out.
USB D-: 3 USB D+: 4 Spread
Press [ Save ] to save Pinout
Total expend 24 seconds
...
->#
...
->#
Operation done, Pin detect out.
BOOT: 5 set as oInvert
USB D-: 3 USB D+: 4 GND:8 9
Press [ Save ] to save Pinout
[G:5 8 9 D-:3 D+:4] Apply to Box
If Scan other phone, please click [Stop]
Pinout has been cleared
Connecting, wait...
User Abort
Scanning pin status,please waiting...
->
Pin-status Scan Done
Scanning,waiting...
->
Operation done, Pin detect out.
BOOT : 2 USB D-: 3 USB D+: 4 Spread
Total expend 52 seconds
...
->#
...
->#
Operation done, Pin detect out.
BOOT: 2 set as ologic
USB D-: 3 USB D+: 4 GND:8 9
Press [ Save ] to save Pinout
[V:2 G:8 9 D-:3 D+:4] Apply to Box
If Scan other phone, please click [Stop]
Checking USB Serial port, wait...
SCI USB2Serial Port: COM83
Connecting, wait...
Phone Connected!
Info: Spreadtrum Boot Block version 2.0
Initialize boot10...
CPU Info 6610
Flash Type NOR
Flash ID 00C80060(00170000)
Flash Model GD27LQ64
Flash Size 0x800000(8,0M)
Start Formatting,Wait...
Format Done.