View Single Post
Old 09-18-2012, 11:11   #3 (permalink)
d-Artigo
No Life Poster
 
d-Artigo's Avatar
 
Join Date: May 2011
Location: gsm-forum
Posts: 4,148
Member: 1573913
Status: Offline
Sonork: hardware illustration
Thanks Meter: 7,630
Quote:
Originally Posted by ashwani gupta View Post
I have changed light ic & coil, still no light in lcd. When we power on phone ,only one time led on in upper & lower keypad .Again press any button, no led light.

Plz give any solution



1. Have a new LCD screen replacements and then replace the LCD.
Check the lcd flex cable. ensure that cable ribbon is properly pinned to the connector.
Replace the whole ribbon cable assemblies if damaged.2. Check or clean the LCD pin connector.
3. Check the inductor coil, and read the VBAT (battery voltage) across to it.
4. Trace the connection line paths of the LCD backlight LED from the pin connector down to the capcitor and resistor where it is being connected. Check or replace also the said components.
5. Replace the backlight LED driver IC.
6. If all of the above doesn't solved the problem, in this level, you may need to rework the betty IC or then replace if necessary. The betty IC holds as the switching circuit of the LCD backlight LED.
Attached Images
File Type: jpg Nokia 6600s lcd display backlight LED solution.jpg (81.3 KB, 13 views)
  Reply With Quote
The Following 2 Users Say Thank You to d-Artigo For This Useful Post:
 
Page generated in 0.10065 seconds with 8 queries