DEAR CHINAKING TEAM I NEED YOUR HELP
I M FACING A PROBLEM IN SKING S9220
Detection initiated...
Vcc: null
Gnd: 1
Analyzing D+ and D-...
D+ = 4, D- = 5
Analyzing USB device, please wait...
Find USB device:SCI USB2Serial (COM6), (VID_1782&PID_4D00)
Internal version: SPRD3
Boot downloaded.
Start boot please wait a moment....
Please put the baud set 115200, try again.
Ready to read/write again, please remove the power supply clip or battery and then re-loaded it.
Detection initiated...
Vcc: null
Gnd: 1
Analyzing D+ and D-...
D+ = 4, D- = 5
Analyzing USB device, please wait...
Find USB device:SCI USB2Serial (COM6), (VID_1782&PID_4D00)
Internal version: SPRD3
Boot downloaded.
Start boot please wait a moment....
Please change Boot or reduce Baudrate, try it again.
Ready to read/write again, please remove the power supply clip or battery and then re-loaded it.
PLZ HELP ME ITS VERY URGENTLY
I M ALWAYS USING ST-7A & P-05B JACK SAME PROBLEM BUT NOT CONNECTING BY RX TX PINOUT
