N7000 Dead boot Programming error...HELP!!! N7000 Dead boot Programming error...HELP!!! Quote:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung N7000 V1.0.4860.58267]
Restarting target (nRST Low then High)...OK
Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.81V, TCK Frequency is 8 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (VYL00M, 0x0003AB400000 Bytes = 14.68 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (VYL00M, 0x000000080000 Bytes = 0.50 MB)
Selected Resurrection Data for the eMMC Chip with Capacity = 14.68GB
Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
.
.
.
.WARNING: Programming Error (0x25) at 0x0000023F8000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x0000023FC000 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x43 (0x000000). Trying to recover...FAILED
ERROR: Failed due to multiple communication errors. Terminating at 0x000000000001
| need solution please...
ano po solution dito mga boss...
Last edited by BABAK NURI; 07-09-2013 at 09:48.
|