GSM-Forum - View Single Post - GPG S-BOOT CABLE.... It has never been easier to repair samsung DEAD boots

cpufix · 10-04-2013, 21:17

I've tried the unit on two S3 i9300 and always get the phone into download mode, but nothing else happens even after say 7 minutes.
This has always occurred since I got the unit - via Ebay

I plugged the unit into a S3 SD slot that was powered on. Comes up "preparing SD Card" so it would be reasonable to assume the SD cable is ok.
Then it tells me the "SD card is blank".

I removed the SD card 2GB from the Unit and connected this up to a Win 7 pc, also shows card is blank.

Discussed with Ebay supplier they requested I post my problem here.

So can you provide a download image for this Unit that I can write to the existing SD card or to a new SD card.
Some questions here.
Any instructions on doing this ?
Does the SD card have to be 2GB, I do have some 8Gb and 16GB SD cards available?
Can the image be used on Win 7 or is it only Linux based ?

10-04-2013, 21:17	#38 (permalink)
cpufix Junior Member Join Date: Oct 2013 Location: Paraparaumu Beach, New Zealand Posts: 1 Member: 2040083 Status: Offline Thanks Meter: 0	Blank SD Card I've tried the unit on two S3 i9300 and always get the phone into download mode, but nothing else happens even after say 7 minutes. This has always occurred since I got the unit - via Ebay I plugged the unit into a S3 SD slot that was powered on. Comes up "preparing SD Card" so it would be reasonable to assume the SD cable is ok. Then it tells me the "SD card is blank". I removed the SD card 2GB from the Unit and connected this up to a Win 7 pc, also shows card is blank. Discussed with Ebay supplier they requested I post my problem here. So can you provide a download image for this Unit that I can write to the existing SD card or to a new SD card. Some questions here. Any instructions on doing this ? Does the SD card have to be 2GB, I do have some 8Gb and 16GB SD cards available? Can the image be used on Win 7 or is it only Linux based ?