..::6120c dead::.. - GSM-Forum

HUM · 07-27-2010, 00:17

6120c dead
set is not water damage
set is damage bcoz fell down only lcd damage,i change lcd,set works fine,i give to customer after 2 days he comes and claim set gone hang and now totally dead

on power supply and press power switch it consumes 0.3 apm

also not connected to software

**Dipendra Pathak** · 07-27-2010, 04:08

That's not your fault. You changed display and gave to customer. you job is finished.

Now, if he want to repair again, check hardware or software otherwise you can reject this job depending nature of customer.

Well, Its dead now, try to flash with latest version of Firmware with DEAD USB mood.

BR

HUM · 07-27-2010, 10:01

i try usb flashing but cmt error

**Dipendra Pathak** · 07-29-2010, 06:33

Did you flash with same product code file??? If not do that.

BR

07-27-2010, 00:17	#1 (permalink)
HUM No Life Poster Join Date: Jul 2005 Location: karachi Posts: 8,673 Member: 161728 Status: Offline Sonork: 100.1582708 Thanks Meter: 2,237	..::6120c dead::.. 6120c dead set is not water damage set is damage bcoz fell down only lcd damage,i change lcd,set works fine,i give to customer after 2 days he comes and claim set gone hang and now totally dead on power supply and press power switch it consumes 0.3 apm also not connected to software

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
..::6630 full short and dead::..	HUM	Nokia Hardware & Hardware Repair	3	09-14-2010 10:40
..::6120c give this error during flashing::..	HUM	Nokia Hardware & Hardware Repair	4	12-25-2008 06:17
..::6120c on/off prints needed::..	HUM	Nokia Hardware & Hardware Repair	1	09-27-2008 19:53
nokia 6280 dead::.	::.::RAMJAN::.::	J.A.F. By Jafsupport.com	22	10-19-2007 10:22
..::n80 short and dead::..	HUM	Nokia Hardware & Hardware Repair	2	09-20-2007 19:28

07-27-2010, 04:08	#2 (permalink)
Dipendra Pathak Product Manager Join Date: Apr 2008 Location: Whitehole throught Blackhole! Posts: 9,582 Member: 747989 Status: Offline Sonork: 100.1593052 Thanks Meter: 8,623	That's not your fault. You changed display and gave to customer. you job is finished. Now, if he want to repair again, check hardware or software otherwise you can reject this job depending nature of customer. Well, Its dead now, try to flash with latest version of Firmware with DEAD USB mood. BR

07-27-2010, 10:01	#3 (permalink)
HUM No Life Poster Join Date: Jul 2005 Location: karachi Posts: 8,673 Member: 161728 Status: Offline Sonork: 100.1582708 Thanks Meter: 2,237	i try usb flashing but cmt error

07-29-2010, 06:33	#4 (permalink)
Dipendra Pathak Product Manager Join Date: Apr 2008 Location: Whitehole throught Blackhole! Posts: 9,582 Member: 747989 Status: Offline Sonork: 100.1593052 Thanks Meter: 8,623	Did you flash with same product code file??? If not do that. BR